Zweimal (einmal bei 9.000 km und einmal bei 13.000 km) gingen das Bedienfeld und die Warnleuchten beim Starten des Motorrads aus. Die Blinker und ihre Warnleuchten funktionierten nicht. Am Kennfeldwähler leuchteten die Kontrollleuchten für die Traktionskontrolle, 1 und 2, konstant. Die ABS-Warnleuchte leuchtete ebenfalls durchgehend. Der Motor lief einwandfrei.
Ich überprüfte die beiden ABS-Sicherungen und alle 9 Sicherungen der einzelnen elektrischen Verbraucher. Keine war durchgebrannt. Ich drehte den Zündschlüssel wieder ein und alles funktionierte einwandfrei. Die Motorkontrolleuchte blieb jedoch an. Im Steuergerät war der Fehlercode P1690 gespeichert. Laut Internetrecherche sollte es sich um eine Störung des Can Bus handeln. Ich habe den Fehlercode zurückgesetzt. Hat jemand die gleiche Erfahrung gemacht? Hat jemand Vorschläge, um zu verhindern, dass dies wieder passiert?
Twice (once at 9,000 km and once at 13,000 km) the control panel and warning lights went out when the motorbike was started. The indicators and their warning lights did not work. On the map selector, the traction control light, 1 and 2 were on steady. The ABS warning light was also on steady. The engine was running smoothly .
I checked the two ABS fuses and all 9 fuses of the individual electrical consumers . None were blown . I turned the ignition key again and everything worked perfectly. However, the engine light remained on . Error code P1690 was stored on the control unit. Searching on the internet, it should be inherent in the Can Bus malfunction. I reset the error code . Has anyone had the same experience? Any suggestions to prevent this from happening again?