Hi guys once again!
I just ordered the ktm kable from stc-shop.at
I will download tune-ecu and then deactivate lamda sensor. Anyone that has used
tune ecu? is it easy to deactivate the lamda sensor?
Deactivating it , is there a chance that i might do something bad to the engine?
Thanks
how do you correct the fueling? Is it possible with the
original KTM tool or do you need something like tunecu ?
Thanks fd,
I am really proud as well! But still as i said i have some minor issues when i installed the kit.
The bike some times runs alone at 2000-2300rpm with the clutch engaged.
But 90 rwhp it's reallyyyyy impresive!!!
it was a fuchs dyno . i dont know if it was broken but the owner is the
engineer of a local supermoto champion and its considered decent.
i know that normal duke 690 R is around 66.6hp at the wheel.
so its not so crazy to see 74.3 with the complete evo 2 kit .
Hello,
owner of a Duke 690R 2011 with 2550km at the moment. Also just installed Evo 2 kit .
Here below todays dyno :
74,3 hp @ 7723rpm at the wheel and
7,6m.kg @ 5879 rpm torque.
Take care all 
I haven't told you something. When i bought the bike brand new , i did all the 2000km only with RON 100. Then i installed the evo 2 kit and started using RON 95 fuel. Then the problems started. Do you think it has anything to do with it?
What RON's do you use?
Yes i have and also we did the throtke position (thad and apad) calibration/check in my engineer.
I dont know as i told before next action will be disabling the lambda sensor.
Any other ideas will be welcomed!
Thanks guys for the resonses!
Today i went again to my engineer and we reinstalled the maps and did the 15 min idle reset.
Again the problem stays the same ? Some times the revs keep at 2200-2700rpm and again when put neutral gear it goes to normal 1400-1700rpm .
I will try to deactivate the lamda sensor and then do the 15 min reset when the engine is cold .
Is it easy to deactivate the lamda sensor? Any guide to do this?
Thanks in advance
Hallo aus Athene Griecheland!
2011 Duke 690 R owner question in english !
I recently purchased a brand new duke 690 R. Done 2000km with it and just installed the EVO 2 Tunning KIT from KTM powerparts in my authorized engineer.
Question :I noticed that when I close the throttle while riding slow, my bike runs alone @ about 2100 rpm and goes only back to the correct idle speed when I action the clutch.
any idea? Please help!
entschuldigung fur die englisch!
